Drainage Submersible Pump BE 80 DERBY 100, 380V
Products from the same category
400.42.001.005M
ID DERBY EX 50, 220V drainage submersible pump for hydrocarbons
$3,053.83
Pre-order only
Description
Application of the pump: pumping loaded liquid, collecting filtrate, lifting liquids contaminated even with hydrocarbons and landfill wastewater from wells or reservoirs, discharging condensing wells, pumping waste water, even contaminated and loaded wastewater. The pumps must not be installed in explosive environments.
Features: open the cast iron impeller to avoid clogging due to loaded liquid, filtrate from landfill and other small solids. Cast iron parts are electroplated to increase their stability. Viton seal. Aisi 316 stainless steel shaft; motor housing with AISI 304 (available on request from AISI 316). Electric pumps are available with a 5 m ID 4G1.5 electrical cable included.
Motor: 2-pole asynchronous motor, 50 Hz, 2850 rpm. Class F insulation. IP68 protection. Operating voltage: single-phase 220V, three-phase 380V. The electric motor is cooled with a non-toxic, non-polluting liquid. The engine is protected by thermal switches that are resistant to temperatures up to 80°C.
Operating conditions: the pump cannot operate in dry conditions. The pump housing is always completely submerged in water. Temperature of the pumped liquid: minimum 0 ° C-maximum 80 °C. Non-freezing place. Vertical working position. Maximum number of launches per hour: 20.
Accessories: Control Panel, Level Controller, BE electronic level sensor, ID 4G1, 5 round cable.
Documentation Drainage Submersible Pump BE 80 DERBY 100, 380V
Download instructions, catalog for Drainage Submersible Pump BE 80 DERBY 100, 380V
Also buy with this product
Good price
-27%
-23%
Low price!
-27%